Medtronic MiniLink REAL-Time Manual Del Usaurio página 22

Question: Why do I see a mix of quick and long flashing red lights on the charger?
about
1 sec
Answer: Your charger AND transmitter batteries are very low. Replace the charger's
AAA battery. If you now get the pattern for very low transmitter battery, leave the
transmitter on the charger for eight hours to recharge. If the red light is still flashing after
eight hours, leave your transmitter on the charger for 24 hours. If the red light is still
flashing after it has been charging continuously for 24 hours, contact the 24 Hour
HelpLine. It may be time to replace your transmitter.
Question: I had my transmitter on the charger for a day. Will this damage my
transmitter?
Answer: It will not damage the transmitter. You cannot overcharge it.
Question: What should I do if the transmitter green light does not flash when connected
to the sensor?
Answer: Is the sensor inserted in the body? If it is not inserted, the transmitter will not
flash green or send signals to your pump.
If the sensor is inserted in the body, you need to disconnect the transmitter from the
sensor, wait for several seconds and then reconnect. If the green light still does not flash,
charge the transmitter.
Question: Why didn't I see the transmitter green light flash after connecting it to the
tester?
Answer: Check the connection. If you still do not see a green light flash, fully recharge
the transmitter battery. Test the transmitter with the tester. If you still do not see a green
light flash, contact the 24 Hour HelpLine. It may be time to replace your transmitter.
Storing the devices
Store the transmitter, charger, and tester in a clean, dry location at room temperature.
Although not required, you may store the transmitter on the charger. If the transmitter is
not in use, you must charge the transmitter at least once every 60 days.
Specifications
Biocompatibility
about about 2 secs
1 sec
Transmitter: Complies with ISO 10993-1 for body contact
about
1 sec
-20-
about
1 sec