Tabla de contenido
© MOSA
REV.0-06/04
SHUT-DOWN FROM FRONT PANEL
1. Position the LOCAL START /REMOTE
START (I6) selector on LOCAL START;
OFF
2.
to shut down the motor in an
ON
START
emergency situation, turn the key
(Q1) to the OFF position;
3. to stop the motor under normal conditions,
proceed as follows:
3a. interrupt the power source, switching off
all tools connected. If a tool does not
feature a power switch, lower the
G.F.I. switch lever (D);
3b. allow the motor to run without any load
for a few minutes;
3c. turn the key (Q1) to the OFF position.
SHUT-DOWN FROM REMOTE
WARNING
The start-up selector (I6) LOCAL START /
REMOTE START enables the start-up and
stop controls for the selected position.
From the REMOTE START position, the
start-up key on the front panel is completely
disabled; to stop the generator, use the
controls on the TCM or EAS panel.
The unit can also be shut down by means of
the TCM 5 remote control or EAS 5 panel.
- Check that the EAS (B3) connector is
connected to the cable from the TCM 5 or
EAS 5 panel.
- Verify or position the LOCAL START /
REMOT START (I6) selector on REMOTE
START.
Shutting down the motor
SHUT-DOWN with TCM 5
Follow the operating procedures for shut-down
under normal or emergency conditions, as
described in the paragraph SHUT-DOWN
FROM FRONT PANEL, using the key (Q1) on
the TCM 5.
SHUT-DOWN with EAS 5
Shut-down is controlled automatically.
See operating manual for the EAS 5 panel.
At the end of each use of the generator, close
the gasoline tap (87).
In case of an extended period of inactivity of
the generator, switch off the motor by closing
the gasoline tap (87); this precautionary
measure serves to avoid probable deposits in
the carburettor.
☞
NB.: as a safety measure the start-up
key must be entrusted to qualified
personnel.
M
GE 4500 HSX
27
Tabla de contenido
