Battery Changing Mode; General Information; Changing The Battery - Fronius Acctiva Smart 25 A Manual De Instrucciones

Battery changing mode

General informa- Battery changing mode supplies the vehicle electronics with power while the battery is
tion replaced. Before disconnecting the old battery from the vehicle electronics, the charger
leads must be connected to the vehicle battery leads. This connection must remain in
place until the new battery is connected.
Changing the bat-
NOTE!
tery
Danger of incorrect voltage setting.
This can result in severe damage to the vehicle electronics.
▶
1
3
NOTE!
Danger if the wrong battery voltage is set.
This can result in damage to property.
▶
Always set the correct voltage after connecting the charger to the vehicle battery
leads.
Plug in charger mains plug
Select Battery changing mode using the up/down keys.
2
Connect the charging leads to the vehicle battery leads as described below - the de-
energised charging leads mean there are no sparks when connecting the battery,
even if the charger is already connected to the mains supply.
- Connect the red charging lead to the positive (+) vehicle battery lead
- Connect the black charging lead to the negative (-) vehicle battery lead
Always ensure that the correct battery voltage is set.
The charger automatically identifies the
battery, e.g. 12 V, and starts powering the
vehicle electronics after 5 seconds.
If the battery voltage is not correctly identi-
fied (e.g. usually the case if a battery is
deeply discharged), you have 5 seconds
to enter the correct battery voltage as fol-
lows:
73