Maintenance - EGO HT2400E Manual De Utilización

SIDE CUTTING
EN
When trimming the sides of the hedge, begin at the bottom and cut upwards
(see Fig. 8). Trim the side of a hedge so that it will be slight narrower at the top.
This shape will expose more of the hedge, resulting in a more uniform growth.
8
SAWING FUNCTION
Although the blade gap allow wood to be
cut up to Ø 22mm, the tip of the blade is
designed to cut wood up to Ø 26mm
(see Fig. 9). If a radical cut is necessary,
cut a little at a time in several stages.
TIP PROTECTOR
The tip protector makes cutting near
the ground or along walls easier while
protecting the special cutters from damage.
22
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
9
Ø 26 mm
Ø 22 mm

MAINTENANCE

WARNING:
When servicing, use only identical replacement parts. Use of any
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
CLEANING
WARNING:
To avoid serious personal injury, always remove the battery pack
from the product when cleaning or performing any maintenance.
 Use a soft brush to remove debris from all air intakes and cutting blade.
 To remove pitch and other sticky residue, spray the blades with resin solvent.
Run the motor briefly so that the solvent is event distributed.
 Wipe the surface with a dry cloth.
WARNING:
Never use water for cleaning your trimmer. Avoid using solvents
when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING BLADE
1. Start and stop your hedge trimmer
until the cutter blade and the guard
are slightly offset (Fig.10). This will
allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from you
hedge trimmer.
3. Clamp the blade assembly in a vise
and file the exposed cutting surface
of each blade tooth. Remove as
little material as possible. Be sure to
retain the original angle of each tooth when filing.
4. Remove the hedge trimmer from the vise; restart it and stop it to expose the
unsharpened edges of the blade teeth.
5. Remove the battery pack and repeat the sharpening procedure above.
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2400E
10
Cutter Tooth
Guard Tooth
23
EN