Kärcher B 150 R 75 Manual Del Usuario página 16

Install D cleaning head
Lift the holder of the cleaning head

(see Chapter "Grey intelligent key/
.../cleaning head replacement".
Slide the cleaning head under the

appliance so that the hose points
toward the rear.
Only slide the cleaning head half-
way under the appliance.
Remove the lid of the cleaning

head.
Connect the power cord of the

cleaning head to the appliance
(same colours must meet).
Replace the lid and lock it.

Slide the cleaning head halfway un-

der the appliance.
Connect the hose couplers on the

cleaning head to the hose on the
appliance.
Insert the tab into the middle of the

cleaning head, between the fork of
the lever.
16
Align the holder of the cleaning

head so that the drilled holes in the
lever and the cleaning head match.
Insert the stop pin through the

bushings and swivel the locking
plate downward.
Insert the cylinder pin into the bor-

ing of the drawbar.
Slide the drawbar with the pin the

guide channel on the cleaning head
all the way to the bottom.
Insert the locking plate into the

guide channel and lock it in.
Repeat process on the drawbar on

the opposite side.
Insert the grey intelligent key.

Set brush type "Disc".

Install R cleaning head
Lift the holder of the cleaning head

(see Chapter "Grey intelligent key/
.../cleaning head replacement".
Slide the cleaning head under the

appliance so that the hose points
toward the rear.
Only slide the cleaning head half-
way under the appliance.
Unscrew the star handle and re-

move the lid.
Connect the power cord of the

cleaning head to the appliance
(same colours must meet).
Slide the lid in and screw tight.

14
-
EN
Slide the cleaning head halfway un-

der the appliance.
Connect the hose couplers on the

cleaning head to the hose on the
appliance.
Insert the tab into the middle of the

cleaning head, between the fork of
the lever.
Align the holder of the cleaning

head so that the drilled holes in the
lever and the cleaning head match.
Insert the stop pin through the

bushings and swivel the locking
plate downward.
Insert the cylinder pin into the bor-

ing of the drawbar.
Slide the drawbar with the pin the

guide channel on the cleaning head
all the way to the bottom and lock.
Repeat process on the drawbar on

the opposite side.
Insert the grey intelligent key.

Set brush type "Brush".
