Step 8: Door Removal And Reinstallation; To Remove The Oven Door - Thermador PRG304GH Instrucciones De Seguridad

3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range (Figure 17).
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.
Installation Instructions
Figure 17: Backguard Installation
Figure 18: Low Back Front View
STEP 8: Door Removal and
Adjustment
CAUTION
• USE CAUTION WHEN REMOVING THE DOOR.
THE DOOR IS VERY HEAVY.
• Make sure oven is cool and power to the oven has
been turned off before removing the door. Failure to
do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands
to remove or replace the door.
• Failure to grasp the oven door firmly and properly
could result in personal injury and product damage.
• With the door off, never release the levers and try to
close the hinges. Without the weight of the door, the
powerful springs will snap the hinges closed with
great force.

To Remove the Oven Door

1. Be sure to read the above
CAUTION before
attempting to remove the
door.
2. Open the door fully.
3. Flip hinge clip down. A
screwdriver may be required
to carefully pry the clip back.
4. Close the door gently until it
stops against the hinge
clips. The open hinge clips
will hold the door open at a
slight angle, about 30°, from
the closed position.
5. Grasp the door firmly on the
ends of the door. Lift the
door up and out. There will
be some spring resistance
to overcome.
6. Place the door in a safe and
stable location.
Figure 19: Door Removal
English 20