Chicco I-Move Instrucciones De Uso página 16

(under the fabric fl ap)
J. Restraint harness adjustment strap
Diag. 3 (Profi le)
K. Abdominal car safety belt slot on the child
car seat
L. Abdominal car safety belt slot on the base
M. Buttons to rotate the carry handle
Diag. 4 (Back)
N. I-MOVE system for fastening to the stroller
O. Diagonal car safety belt slot
P. Release handle (from the base and the
stroller)
Q. Belt threading slots
R. Stabiliser block
(*) Shape and model can differ according to the
child car seat version being used.
(**) Optional
1.4 POSITIONS OF THE HANDLE
The child car seat carry handle can be adjusted
to 4 positions (Diag. 5)
A. Position when travelling by car (WARNING:
this is the only position allowed when travel-
ling by car).
B. Position when carried by hand.
C. Rocker chair mode position or when you need
to fasten it to an appropriate Chicco stroller.
D. Fixed rocker chair position.
To adjust the position, press both buttons (M) on
the handle bar together and rotate it to the de-
sired position until you hear it click into place.
1.5 RESTRICTIONS AND REQUISITES RE-
GARDING THE USE OF THE PRODUCT AND
CAR SEAT
WARNING!
Read these restrictions and requisites carefully
to ensure the product and car seat are used
safely: if you don't, the safety levels cannot
be guaranteed.
• The child car seat can be fi tted onto the front
passenger seat or any other back seats. In any
case the vehicle seat must be facing forwards.
Never use this child car seat on vehicle seats
which are facing sideways or facing rearwards
(diag. 6)
• The vehicle seat must be fi tted with a
3-point static or 3-point retractor safety belts
approved to UN/ECE Regulation No.16, or
other equivalent standards (Diag. 7).
• WARNING! Never fi t the child car seat to a
vehicle seat that is only equipped with a
2-point safety belt (Diag. 8)
• Never use the booster cushion if the child
weighs more than 6 kg.
2. CAR INSTALLATION
The child car seat can be installed:
- with a standard base, to be fi tted only with
3-point safety belts (optional);
- without a base;
- with an ISOFIX base, to be fi tted using the
ISOFIX system and, alternatively, with 3-point
safety belts (optional)
In all three cases, the child car seat must always
be installed facing rearwards.
2.1 INITIAL CONFIGURATION OF THE HAR-
NESS STRAPS AND SHOULDER PADS
The child car seat is fi tted with a booster (up
to 6kg) in addition to the shoulder pads. The
product is also supplied with a pair of shoulder
pads for use when the booster becomes obsolete
(over 6kg). In both cases, thread the harness
straps through slots in the shoulder pads so
that the harness straps stay on top of them (see
diag. 9a-9b-9c).
Thread the harness buckle through the crotch
pad (see diag 10).
2.2 INSTALLATION WITH THE STANDARD
BASE (3-point safety belts)
To install the child car seat with base on the
vehicle seat, proceed as follows:
1. Remove the child car seat from the base by
pulling the release lever behind the backrest
whilst using the carry handle to lift it upwards
(Diag. 11).
2. Position the base on the chosen vehicle seat,
position it as seen in Diag. 12 so that it touches
the vehicle seat backrest.
3. Pull the vehicle safety belt and connect it to
the relative buckle, threading the horizontal
abdominal through the two slots (L) indicated
by the light blue arrow; pull it as tight as pos-
sible (Diag. 13).
16