Information On The Display - NUK Eco Control Audio 530D+ Instrucciones De Operación

– As soon as the parent unit 12 comes
back into range, or the reason for the
breakdown
eliminated, the connection indicator 18
lights up green again indicating that the
units are able to communicate.
– When the units are first switched on,
the connection indicator 18 will initially
be red. The parent unit and baby unit
will set up a connection. As soon as the
connection is set up the display will
turn green.
• The power supply indicator POWER 20:
– lights up green: the device is switched
on and the battery is fully charged;
– flashes green: the battery currently
being charged;
– lights up red and beeps at one minute
intervals: low battery warning. Within
about 15 – 20 minutes the parent unit
will switch off automatically. Please be
aware that this interval may
reduced, depending on how you use
the device (for example, VOX level 5
uses more power than level 1).
• The display 21 with the 5 LEDs has three
functions. The LEDs are only visible when
in use.
– indicates the noise level in the nursery.
The more LEDs are lit, the louder are
the noises;
– indicates the different levels when you
are adjusting the volume. The more
LEDs are lit, the louder will be the
sound from the loudspeaker;
– indicates the different levels when you
are adjusting the VOX sensitivity. The
more LEDs are flashing, the sooner the
device will react to sounds. If 5 LEDs
are lit the device will switch to
continuous transmission.

6.3 Information on the display

The display 17 is illuminated and lights up
automatically as soon as you perform any
operation on the parent unit 12.
in communications
To save power, the light will automatically go
out if you perform no further operations for a
period of 30 seconds.
is
The display 17 shows you the following
information:
• The TALK symbol is visible only
while the talk-back function is
active (see "6.9 Talking to your
baby" on page 41).
• The musical note symbol will be
visible only if lullabies have been
activated from the parent unit
(see "6.10 Lullabies"
be
page 41) or baby unit (see
"5.3 Lullabies" on page 36).
• The vibration symbol can be
seen on the display 17 only if
you have activated the vibrating
alarm (see
vibrating alarm" on page 40).
• The lightbulb symbol will be
visible only if the nightlight has
been activated from the parent
unit (see "6.11 Nightlight" on
page 42) or baby unit (see
"5.4 Nightlight" on page 37).
• The display
shows
temperature
updated automatically (see "6.12 Room
temperature" on page 42).
• The time can be set up
by hand and is then
permanently displayed
(see "6.4 The
display and setting the clock" on
page 39).
38
on
"6.7 Setting the
always
the room
and is
time