First Use; Fitting / Removing Brush Heads - Nevadent DAZD 3.7 Li B2 Instrucciones De Uso

First use

NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads
with fresh water.
3) Open the lid of the charger
the replacement brush heads on the brush
holders. Re-close the lid
4) Place the handset on the charger
it slides onto the pin on the base.
5) Allow the handset to charge up for around
14 - 16 hours before using it for the first
time. The charge indicator
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator
Then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the
charge indicator
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
8) You can now leave the handset in the char-
ger after every use, so as to always have
full power available.
DAZD 3.7 Li B2
and place
.
so that
on the front of
blinks red.
lights up green.

Fitting / removing brush heads

■ When fitting the brush head
straight and with the bristles facing forwards
towards the handset.
■ To remove the brush head
and off.
NOTE
For information on ordering replacement brush
heads, read the section „Ordering replacement
parts".
You can also use the replacement brush heads
from Oral-B ® * electric toothbrushes for this
appliance (except Pulsonic models).
* Oral-B is a registered trademark of Procter &
Gamble Co.
, attach it
, pull it upwards
GB │ MT │
35 ■