Operation; Brushing Teeth - Nevadent DAZD 3.7 Li B2 Instrucciones De Uso

Operation

This toothbrush has 3 different performing levels:
–
"Clean": normal speed,
orange "Clean" LED
For cleaning the teeth.
–
"Soft": slow speed,
green "Soft" LED
For cleaning the teeth of people with
sensitive gums.
–
"Pulse": alternating speeds,
yellow "Pulse" LED
For massaging the gums.
■ Press the on/off switch
"Clean" mode. The "Clean" LED
■ Press once more to switch to "Soft" mode.
The "Soft" LED lights up.
■ Press it a third time to switch to "Pulse" mode.
The "Pulse" LED
■ To switch the toothbrush off, press the on/off
switch once more.

Brushing teeth

WARNING!
Due to the unaccustomed effect of the tooth-
brush, there may be some initial gum bleeding.
This is normal. If this continues for more than
two weeks, you should consult your dentist.
1) Place the brush head
2) Moisten the brush under flowing water.
3) Put a little toothpaste onto the wet brush.
■ 36 │ GB │ MT
once to activate the
lights up.
lights up.
on the handset.
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) Use the On/Off switch
operating mode (see section „Operation").
NOTE
This toothbrush has a 30-second interval timer,
so that all four jaw quadrants can be cleaned
evenly.
5) Divide your mouth into four parts (quadrants):
upper left, upper right, lower left and lower
right.
6) Start in one quadrant:
Start with the brush head
and move the brush upwards/downwards
from the gums to the crown of the tooth.
Proceed in this manner on both the inside and
the outside of the tooth. Start again at the
gums for each individual tooth.
Do not forget to brush the back of the rear
molars.
To clean the chewing surfaces, guide the
oscillating brush head over the chewing
surfaces with a little pressure.
to select the desired
on your gums,
DAZD 3.7 Li B2