Service; Appliance-Specific Safety Instructions; Safety Instructions For All Saws; Further Safety Instructions For All Saws - Parkside PTS 710 A2 Traducción Del Manual De Instrucciones Original

h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in unex-
pected situations.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety
instructions

Safety instructions for all saws

Sawing method
a) DANGER! Keep your hands clear of
the sawing area and the saw blade.
Hold the auxiliary handle or motor
housing with your other hand. If you are holding
the saw with both of your hands, neither can be
injured by the saw blade.
b) Do not reach underneath the workpiece. The
blade guard cannot protect you from the saw
blade underneath the workpiece.
c) Set the cutting depth to match the thickness
of the workpiece.The blade should not extend
more than one full tooth depth under the work-
piece.
d) Never hold the workpiece that you want to
saw in your hand or over your leg. Fasten the
workpiece onto a stable working surface. It is
important to fasten the workpiece securely to
minimise the danger of bodily contact, jamming
of the saw blade or loss of control.
PTS 710 A2
e) Always hold the power tool by the insulated
gripping surfaces when performing an op-
eration during which the cutting tool may hit
hidden wiring or the tool's own power cord.
Contact with a live wire will also make exposed
metal parts of the power tool live and could
give the operator an electric shock.
f) When making longitudinal cuts, always use
a rip fence or a straight edge guide. This will
improve the accuracy of your cut and reduce
the likelihood of the saw blade jamming.
g) Always use saw blades of the correct size
and with an appropriate central attachment
hole (e.g. star-shaped or round). Blades that
do not match the mounting hardware of the saw
will run eccentrically, causing loss of control.
h) Never use damaged or incorrect blade
washers or bolts. The saw blade washers and
screws have been specially designed for your
saw to provide optimum performance and oper-
ational safety.
Further safety instructions for all
saws
Kickback – causes and corresponding safety tips:
–
A kickback is a sudden reaction caused as a
result of the saw blade catching, jamming or
being falsely aligned that cause the saw to
jump up uncontrollably and out of the work-
piece in the direction of the operator;
–
if the saw blade catches or jams in a narrowing
saw cut, the blade can no longer rotate and the
power of the motor throws the appliance back
in the direction of the operator;
–
if the saw blade twists in the saw cut or be-
comes misaligned, the teeth at the rear edge of
the saw blade can become caught in the sur-
face of the workpiece, causing the saw blade to
jump out of the cut and the saw to jump back-
wards in the direction of the operator.
GB │ MT │
59 ■