Connecting The Speakers And Subwoofer - JVC RX-6042S Manual De Instrucciones

Getting Started
AM antenna connections
AM
EXT
AM
LOOP
FM 75
COAXIAL
ANTENNA
2
1
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you have the best reception.
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as illustrated.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal. (Keep the AM loop antenna
connected.)

Connecting the Speakers and Subwoofer

You can connect five speakers (a pair of front speakers, a center
speaker, and a pair of surround speakers) and a subwoofer.
CAUTIONS:
• Use only the speakers of the SPEAKER IMPEDANCE
indicated by the speaker terminals.
• Do not connect more than one speaker to each speaker
terminal.
6
AM Loop Antenna
(supplied)
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop
antenna.
3
Connecting the speakers
For RX-6042S
1 2
For RX-5042S
1 2
For each speaker (except for a subwoofer), connect the (+) and
(–) terminals on the rear panel to the (+) and (–) terminals
marked on the speakers.
For RX-6042S
To center speaker
To right front speaker
To right surround speaker
For RX-5042S
To center speaker
To right front speaker
To right surround speaker
3
4
3
4
To left
front speaker
To left surround
speaker
To left
front speaker
To left surround
speaker