Reset Schedule - Mitsubishi Electric RedLINK MHK2 Manual De Operación

Reset Schedule

To reset the controller schedule back to the default
temperature settings (see "Scheduling Options" on
page 10), follow steps below.
Touch Menu on the controller screen.
1
2 Touch the or
RESET, then touch Select.
3 Touch the or
SCHEDULE, then touch Select.
Touch Yes to confirm.
4
Note: The reset schedule menu option is
available only if the schedule is enabled in
the controller Installer Setup menu.
Note: If you switch from a previously saved
program, either Residential or Commercial,
to Commercial or Residential respectively,
you must also enable a Schedule Reset
after saving the change to reflect the correct
program defaults.
33-00447EFS_B.indd 12
arrows until you see
arrows until you see
12
10/17/2019 3:22:55 PM