PRODUCT SPECIFICATIONS
ENGINE
Engine Type ........................................ MZ360, 357cc, OHV
Cooling System ...................................................Forced Air
Starting System ......................................... Recoil/Electrical
Ignition System ........................................................... T.M.I.
Spark Plug .....................................................NGK BPR4ES
Engine Lubricant Volume...........................................1.1 qt.
Fuel Volume ................................................................ 8 gal.
KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKERS
The circuit breakers are provided to protect the generator
against electrical overload.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
CHOKE
The choke is used when starting a cold engine.
CORD RETAINERS
Use the cord retainers to prevent plugs from being
accidentally pulled out of the receptacles.
ENGINE SWITCH WITH SWITCH KEY
The engine switch with switch key is used to turn the generator
engine on and off.
EXTENSION CORD
A 25 ft. extension cord equipped with a twist-lock plug on
one end, two circuit breakers and four 120V receptacles on
the other is provided with the generator.
FUEL TANK
The fuel tank has a capacity of 8 gallons.
FEATURES
GENERATOR
Rated Voltage .....................................................120V/240V
Rated Amps ..................................................... 56.7A/28.3A
Rated Output ...........................................................6800 W
Starting Watts ..........................................................8500 W
Rated Frequency ........................................................60 Hz
DIMENSIONS
Length ..................................................................... 29.5 in.
Width .......................................................................... 28 in.
Height ......................................................................... 26 in.
Weight ................................................................. 222.5 lbs.
FUEL VALVE
The flow of fuel through the generator is controlled by the
position of the fuel valve.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
oil in the crankcase is insufficient.
MULTIFUNCTIONAL DISPLAY
The multifunctional display indicates voltage, frequency and
the total number of hours the unit has been used.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAINAGE BOLT
When changing the engine lubricant, unscrew and remove
the oil drainage bolt to allow old engine lubricant to be
drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz outlets:
four 120 Volt AC, 20 Amp receptacles, and one 240 Volt
AC, 30 Amp receptacle. These can be used for operating
appropriate appliances, electrical lighting, tools, and motor
loads.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the engine
switch) to start the generator's engine.
Page 10 — English