Troubleshooting/Remedy; Connections - Attas GAMMA 60 Manual Del Usario

22 Troubleshooting/remedy

Description
LED PROG + CANC
Slow flashing
LED PROG + CANC
Rapid flashing
Description
Lighting does not work.
No door movement when hand-held
transmitter is activated.
Unsatisfactory hand-held transmitter
range.
No door movement.
Door stops during course of movement. Door moves with difficulty, check door mechanics and replace if necessary (to be
Door changes direction during
movement.
Motor is running but the door does not
move.

23 Connections

M
+gn
3 4 5
6 1 2
30 / 147
Possible cause
- Light barrier triggered or faulty
- Power shutdown
- Motor fault
- Hall sensor fault
- Overvoltage or undervoltage
- Processor fault
- Peripheral fault
Fault rectification
Replace faulty bulb.
- Check battery in hand-held transmitter and replace if necessary.
- Teach in the hand-held transmitter.
- Check antenna connection.
- Check battery performance in the hand-held transmitter and replace if necessary.
- Check supply and mains fuse.
- Is wire jumper present (Section 16.1)?
- Check function of connected safety equipment (e.g. light barrier).
carried out by specialised personnel only!)
- Check whether there is an obstacle in the path and remove if necessary.
- Check whether the door is correctly set to the CLOSED position and teach in again if
necessary.
Running slide (L) must be latched into the carrier (H) and locked (see Section M2,
page 112).
24V 0V
7
-rt
Version 1.0
Remedy
The fault status is automatically reset once the
fault cause has been rectified and a new start
pulse has been given
Switch power supply off and on (wait approx. 10
seconds).
- Antenna 6 + 5 (shielding)
- Pulse 1 + 2
- Light barrier
3 = +
4 = Contact
5 = -
Jumper between 4 and 5 if there is no light barrier
- Ground/earth 7
GAMMA 60 / 80