Tabla de contenido
Idiomas disponibles
Idiomas disponibles
install wheel straps
(if not installed earlier)
Slide the open wheel straps
onto the wheel tray with the
red buttons towards you.
load and secuRe YouR bIke — (bIke WeIght lImIt Is 30 lbs.)
Set your bicycle in
the wheel tray with
the hoop lying flat
between the wheels.
IN THE OPEN POSITION, JAWS SHOULD CLEAR THE BIKE FRAME.
Raptor can mount above or below most attachments,
such as waterbottles.
Some attachments on the down tube must be removed if
the jaws cannot attach above or below them.
Pull the strap through
wheel spokes on the
front and rear wheels.
do not let the strap push
against the valve stem.
unloadIng bIcYcle:
release the strap by
pushing the red button.
1033402A-/18
wheel of the
bicycle must
rest inside the
to avoid paint wear,
clean contact points
on frame before
tightening Jaws.
close the stRaps
• Insert the strap
end behind the
red tab.
• TIGHTEN the strap
by repeatedly
lifting the red tab.
do not overtighten
the strap!
Unscrew red knob and
roll bicyle out of hoop.
Install tRaY end caps
note:
the front
Raise hoop and roll
bicycle forward
as jaws meet the
down tube.
hoop.
befoRe dRIvIng aWaY
• Check the knob.
• Check both wheel straps.
• TIGHTEN IF NECESSARY.
do not
overtighten!
tIghten Red
knob
do not overtighten!
• If the wheel is still loose
in the tray slide the strap
in the tray until it rests
against the rim.
• TIGHTEN AGAIN.
Tabla de contenido
