Yakima Raptor aero Guia De Inicio Rapido página 4

attach Wheel tRaY to
hoop assemblY
• Insert baseplate bolt head 8" into slot in wheel tray.
• Use the washers and wing nut to attach the hoop
baseplate onto this bolt.
• Slide the wheel tray bolt into the track
at the other end of the wheel tray.
8"
(20 cm)
factoRY cRossbaRs onlY:
combine tray/hoop assembly with universal mightymounts
long
cARRiAge bolt
(raptor aero baseplate)
SPAceR
nut
uPPeR PAd
SPACER POSITIONING—
if your factory bars are angled, and the spacer is
not flat against the baseplate, loosen the carriage
bolt and rotate the spacer as needed.
You will need to remove the pad. Be sure to
replace it once the bolt is tightened.
Round oR squaRe cRossbaRs: set tray/hoop assembly onto crossbars.
• insert two baseplate bolts up through
the SnapArounds and baseplate.
• Secure with elongated hex keys.
• insert the wheel tray bolt through the
SnapAround on the other crossbar.
• Secure with short hex key.
1033402A-4/18
remove the upper pads
before continuing.
• Insert a long carriage
bolt through the Raptor's
baseplate.
• Add the spacer to the
Universal MightyMount
and secure with nut.
• Tighten with supplied
wrench.
• Reattach the upper pad
(bASePlAte)
ON SOME SMALLER BIKES—
if the wheel straps need to be between the
crossbars, slide them onto the wheel tray now.
standard bikes:
install wheel straps outside the
crossbars after steps 18 or 19.
SMALLER BIKES ONLY:
Slide the open wheel
straps onto the wheel
tray with the red buttons
towards you.
SPAceR
Tighten all
3 hex keys
firmly onto all
SnapArounds.
note: hoop must rest horizontally on tray
while turning the hex keys. when hoop is
raised the hex keys cannot be turned.
rear wheel traY
requires the short
carriage bolt.