Yakima Raptor aero Guia De Inicio Rapido página 2

factoRY cRossbaRs onlY:
Start here to find the Universal MightyMount
parts that fit your crossbars.
Install pads to one set of mounts.
Press a pad into the
smaller bail (marked "A").
place the mount onto the bar, opening toward the front of the car.
• Close and compress the
mount around the bar.
• Insert a short hex bolt into
the hex opening in the barrel
sleeve, and insert into mount.
Always use the short bolt with small bail — and long bolt with large bail.
If the bolt threads still do not
extend below the closed bail:
• Use the larger bail (marked "B")
with longer bolt.
• Repeat step 2 and 3.
Remove the fitted mount from the bar.
• Assemble the remaining mounts, and
carefully set them aside.
• do not discard the unused parts (you
may use them on future vehicles).
• continue to SteP 9.
1033402A-2/18
Press a pad into the backbone.
(You may need to rotate the pad
to fit correctly.)
always install the
pad on the bail for
this fitting process.
attach small baIl to
backbone.
Use the upper hinge slot
on the backbone.
bAckbone
Bolt threads
mUSt extend
below the
closed bail.
IF THE BOLT DOES NOT EXTEND,
remove the bail, and set the end
into the lower slot.
attach the thumb-wheel:
If there is any looseness, or the mounts can slide
on the bar, follow the fitting process again.
repeat the fitting process
until the mightymount
conforms to the size of your
crossbars when the wheel
is tightened.
Round oR squaRe
cRossbaRs,
continue to step 7.
bAil