Transportation; Warranty - MTD H15 Manual Del Usaurio

English
Unscrew spark plug to the left

with a spark plug wrench.
Check/adjust the electrode

gap of 0.6–0.7 mm (Fig. 27).
Note
Replace a damaged, sooted
or dirty spark plug.
Screw in spark plug and tighten

to a torque of 12.3–13.5 Nm.
Do not tighten too tightly.
Cleaning the exhaust
Fig. 28
Clean the area under the exhaust
cover (1) every 25 operating hours.
To do this, the exhaust cover must
be removed.
This work may be carried out
by a specialist workshop only.
Checking/topping up the
grease in the gearbox
Fig. 29
Check the level of grease in the
gearbox every 25 operating hours.
To do this, remove the screw (1).
If required, refill with a high-quality
lithium grease.
This work may be carried out
by a specialist workshop only.
12
Cleaning the unit
Caution
Always keep the unit and venti-
lation slots clean and free of dirt.
Use a small brush for cleaning
the outside of the unit.
Do not use abrasive detergents.
Household cleaners which contain
aromatic oils such as pine oil
or lemon as well as solvents
such as kerosene may damage
the plastic housing and handle.
Wipe housing with a damp cloth
only.
Storage
Never store the unit with fuel

in the tank or in a location where
petrol vapours may be ignited
by a spark or naked flame.
Before storing the unit, leave

the engine to cool down.
Store the unit in a dry, closed

room to prevent unauthorised
use or damage.
Keep the unit away from children.
Long-term storage
If the unit is to be stored for a pro-
longed period, proceed as follows:
Drain all the fuel out of the tank

and pour into a container with
the same two-stroke mixture.
Do not use fuel which has been
stored for longer than 3 days.
Start the engine and leave

running until it stops.
This ensures that there is no fuel
left in the carburettor.
Leave the engine to cool down.

Take out the spark plug and pour
30 ml of a high-grade engine oil
or two-stroke oil into the cylinder.
Slowly pull the starter rope
to distribute the oil.
Reinstall the spark plug.
Operating manual
Note
Take out the spark plug and pour
all the oil out of the cylinder before
starting the unit after storage.
Thoroughly clean the unit and

check for loose and damaged
parts.
Repair or replace damaged parts
and tighten loose screws, nuts
and bolts.
The unit can now be stored.
Store the unit in a dry, closed

room to prevent unauthorised
use or damage.
Keep the unit away from children.

Transportation

Before transporting the unit,

leave it to cool down.
Empty the fuel tank before trans-

porting the unit.
Tank cap must be closed tightly.
Secure the unit to prevent it from

shifting during transportation.

Warranty

The warranty regulations issued
by our company or the importer
are valid in all countries.
We shall repair any faults on your
unit free of charge in accordance
with the warranty, provided the fault
was due to defective materials
or manufacturing. If claiming under
the warranty, please contact your
seller or your nearest branch.