Electrical Safety - Senix CSE12-M Operator's Manual

ON/OFF SWITCH.
• Use the right tool. Only use this tool for
its intended purpose.
• Always hold the unit with both hands when
operating. Keep a firm grip on both handles
or grips.
• DO NOT overreach. Always keep proper
footing and balance. Take extra care when
working on stairs, steep slopes or inclines.
To avoid serious injury, DO NOT operate
the unit while on a ladder or a roof.
• Keep hands, face, and feet away from all
moving parts. DO NOT touch or try to stop
moving parts.
• DO NOT touch the engine or muffler. These
parts get extremely hot from operation,
even after the unit is turned off.
• DO NOT operate the unit faster than the
speed needed to do the job. DO NOT run
the unit at high speed when not in use.
• DO NOT force the unit. It will do a better,
safer job when used at the intended rate.
• Always stop the unit when operation
is delayed or when walking from one
location to another.
• Before setting the unit down, always MAKE
SURE the engine is off and all moving parts
have stopped.
• If you strike or become entangled with a
foreign object, stop the unit immediately
and check for damage. DO NOT operate
the unit before repairing damage. DO NOT
operate the unit with loose or damaged
parts.
• Unplug the unit for maintenance or
repair.
• Use only original equipment
manufacturer (OEM) replacement parts
and accessories for this unit. Use of any
other parts or accessories could lead to
serious injury to the user, or damage to the
unit, and void the warranty.
• Keep the unit clean. Carefully remove
vegetation and other debris that could
block moving parts.
• To reduce fire hazard, keep air vents
free from grass, leaves or excessive
grease.
• If the unit starts to vibrate abnormally,
stop the unit immediately. Inspect the unit
for the cause of the vibration. Vibration is
generally an indicator of trouble.
4

ELECTRICAL SAFETY

WARNING!
Do not permit fingers touch the terminals
of plug when installing or removing the
extension cord from the plug.
1. Double insulated tools are equipped
with a polarized plug (one blade is
wider than the other and will require
the use of a polarized extension
cord. The Chain Saw's plug will fit into
a polarized extension cord only one
way. If the plug does not fit fully into the
extension cord, reverse the plug. If the
plug still does not fit, obtain a correct
polarized extension cord. A polarized
extension cord will require the use of a
polarized wall outlet. This plug will fit into
the polarized wall outlet only one way.
If the plug does not fit fully into the wall
outlet, reverse the plug. If the plug still
does not fit, contact a qualified lectrician
to install the proper outlet. Do not
change or alter the equipment plug,
extension cord receptacle, or extension
cord plug in any way.
2. Double insulation eliminates the need
for the three-wire grounded power cord
and grounded power supply system.
Applicable only to Class II (double-
insulated) tools. This Chain Saw is a
double insulated tool.
WARNING!
Circuit Interrupter) protection should be
provided on all circuits or outlets to be
used for electric chain saws and lawn
and garden power tools. Receptacles are
available having built-in GFCI protection
and should be used for this measure of
protection.
• Double insulation DOES NOT take the
place of normal safety precautions when
operating this tool.
• Guard against electric shock: Prevent
body contact with grounded surfaces.
For example: metal pipes, wire fences.
3. BEFORE plugging in the tool, BE SURE
that the outlet voltage supplied is within
the voltage marked on the tool's data
plate. DO NOT use 'AC only" rated tools
with a DC power supply.
WWW.SENIXTOOLS.COM