Senix CSE12-M Operator's Manual página 12

FILLING THE AUTO OIL SYSTEM
CAUTION!
The chain saw is NOT supplied filled with
oil. It is essential to fill with oil before use.
Never operate the chain saw without chain
oil or at an empty oil tank level, as this will
result in extensive damage to the product.
Chain life and cutting capacity depends on
optimum lubrication. Therefore, the chain is
automatically oiled during operation via the
oil outlet.
This chain saw features an auto-oiling system
to keep the chain and chain bar properly
lubricated. The oil level indicator shows the
remaining oil in the chain saw. If the oil level
decreases to below one quarter capacity, refill
it with the proper bar and chain oil.
To fill the oil reservoir:
1. Remove the oil cap (Fig. 4). Fill the
reservoir with bar and chain oil (SAE30)
until the oil level has reached full capacity.
2. Put the oil cap back on. Make sure to
check the oil level after every 10 minutes of
use. Unplug the chain saw before checking
oil levels or filling the oil reservoir.
CAUTION!
To prevent oil leakage, ensure machine is left
in a horizontal position (oil filler cap upright)
when not in use. Use only the recommended
oil to avoid damage to the chain saw. Never
use recycled/old oil. Use of non approved oil
will invalidate the warranty.
ATTACHING THE EXTENSION CORD
Remove the plug safety cap (Fig. 5). Insert
the extension cord socket into the chain saw
plug.
An extension cord retainer is attached to the
handle to reduce strain on the cord (Fig. 5).
To use the cord retainer, double the extension
cord as shown, about a foot from the end,
and insert it into the end of the retainer. Place
the loop formed by doubling the cord over the
hook. Gently tug on the cord to ensure that it
is firmly situated in the retainer.
Keep the extension cord clear of operator,
unit, and any obstacles at all times. Do not
expose the cord to heat, oil, water, or sharp
edges.
12
Oil Level Indicator
Oil Cap
Fig. 4
Completed
Fig. 5
WWW.SENIXTOOLS.COM