Calculating The Capacity Of The Plate Dispensing Tubes - Hupfer SPTW-2/EBF/TEHCO Manual De Instrucciones

Operation
Adjusting the plate dispensing tube
Procedure for setting the springs:
§
Take the inserted crockery items out of the plate dispenser (if available).
§
Hook or unhook adjustable springs uniformly in all groups of springs.
§
Preferably unhook the adjustable springs. Always leave the base springs inserted, if possible. Always
unhook the springs on the lower attachment bar.
Both steps must be repeated as often as possible, until the dispensing height is in the range from 1.57'' (4
cm) to 2.36'' (6 cm). So long as the same kind of crockery is always used, the dispensing height only needs
to be set once.
NOTE
NOTE
5.2.3

Calculating the capacity of the plate dispensing tubes

The capacity of the plate dispensing tube depends on the type of crockery used.
All the leading manufacturers give the necessary data for calculating the intermediate stack height in the fol-
lowing manner:
T
he capacity per crockery stack can be calculated together with the stack height H
Figure 7
91319926_A0
Arrangement of the springs
For guiding the guide basket uniformly and without friction, a symmetrical
arrangement of springs between the attachment bars is necessary.
A slightly asymmetrical arrangement of springs within an attachment bar does
not pose any problem.
Spring system
Since the plate dispensing tubes are designed for a maximum crockery load,
the available spring system of the appliances is entirely sufficient for all usual
market
Owing to the base springs with higher tension, the plate dispensing tubes are
unsuitable for plastic items.
H : Intermediate stack height
Z
H : Height of the first crockery item
1
H : Height of n crockery items
n
n: Number of crockery items
K: Items per crockery stack
H : Stack height of the plate dispenser
S
Intermediate stack height H of 11 crockery items
z
Chapter 5
Page 23
plates.
:
S
Food transport trolley
SPTW-2/EBF/TEHCO