Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Whenever a DiSEqC program is sent, the commands that correspond to the
equipment status in relation to the Horizontal or Vertical polarization and High or Low
frequency band are also sent. This allows assuring that the installation status is the one
indicated by the equipment.
5.19
SATCR function
By means of function SATCR it is possible to control the devices of a TV
installation satellite that are compatible with the SatCR
Router), which allows to concentrate manifold down frequencys (slots) by an only cable.
By this way each user using a slot can tune and decode any signal present in the
satellite.
In order to select the SATRC function, press the DiSEqC key [21] from frontal
panel, and using the rotary selector [1] activate the SATRC option. In the display are
the configuration options that users can modify: slot selection, number of slots, device
address, Frequency sep, pilot signal activation, and finally the frequencies
corresponding to each slot.
When activating the Enable Pilots options, the SatCR device located in the
headend emits a pilot signal with constant level for each down frequency (slot). This
function facilitates the verification and identification for different satellite channels that
are available in the installation. The SatCR technology is being developed and tested in
many countries.
8
SatCR is a trademark of STMicroelectronics.
Page 56
SATCR
DiSEqC
» SELECTED SLOT:
» NUMBER OF SLOTS:
0
20
» ADDRESS:
40
60
» STEP:
FREQ:
1300.02 MHz
» ENABLE PILOTS:
DL-Ku:
11900.0
MHz
» SLOT 1:
CH:
2
MHz
» SLOT 2:
EXIT
Figure 37.- SatCR command screen.
USER'S MANUAL. PRODIG-3
8
technology (Satellite Channel
1
2
80
100
0
120
1 MHz
» LEVEL:
30.0
dBµV
OFF
C/N:
7.6
dB
950.05 MHz
1419.96 MHz
03/2008
Capítulos
Tabla de contenido
