Datalogger For Attenuation And If Sat Tests - Promax PRODIG-3 Manual Del Usaurio

USER'S MANUAL. PRODIG-3
After selecting the START field the instrument begins to carry out the available
measurements automatically. Once completed, the process will be ready to repeat
again (for example, for a new test point), or view measured data by turning the rotary
selector [1], or store the information in memory (SAVE) or exit from this acquisition
(EXIT).

5.10.1 DATALOGGER for Attenuation and IF SAT tests

The PRODIG-3 allows to make measurement acquisitions while executing an
Attenuation test at terrestrial band or an IF SAT test at satellite band (see section
"5.11 Verification of distribution networks").
For it, one of these tests should be activated previously as the following figure
shows.
In order to make the automatic acquisition of these measurements, select it from
UTILITIES menu by pressing the
option, and later the NEW DATALOGGER option. In the CHANNEL SET field will
appear the type of test that the instrument is going to store automatically.
03/2008
10
0
-10
-20
FREQ: 48.30 519.25
REF: 90.6 83.7
TEST: 86.3 73.1
ATT: 4.3 10.6
CALIBRATE
Figure 11.- Attenuation Test. Terrestrial band.
[22] key, and activating the RUN DATALOGGER
631.25 MHz
83.6 dBuV
70.2 dBuV
13.4 dB
EXIT
Page 31