Automatic Transmission Search; Selecting The Measurement Configuration: Analogue/ Digital Signal; External Units Power Supply - Promax PRODIG-3 Manual Del Usaurio

In frequency tuning mode there are two ways of tuning:
1. Turning the rotary selector [1].
Turning the rotary selector [1] selects the desired frequency (tuning is
continuous from 45 to 865 MHz and from 950 to 2150 MHz). When turning it
clockwise frequency increases while turning it anticlockwise frequency
decreases.
2. Using the keyboard.
Press the rotary selector [1] (the frequency listing will disappear and will
appear on the upper left corner of screen the keyboard symbol of manual data
entry
keyboard. The PRODIG-3 will calculate the tuneable frequency closest to the
entered value and then display it on-screen.
5.5

Automatic Transmission Search

Holding pressed the
level higher than the search level. The threshold level is defined by means of the Min.
Ter. Level for analogue channels and Min. Ter. Power, Min. Sat. Power for digital
channels from PREFERENCES menu.
5.6

Selecting the measurement configuration: Analogue/ Digital signal

Measuring the characteristics of a channel depends, in the first place, on the type
of modulation: analogue or digital.
Use key
[17] key to show the measurements CONFIGURATION menu and select the
Signal option by turning and pressing the rotary selector [1]. The Signal option allows
setting the type of signal to measure. When switching to a new type, the PRODIG-3
activates the last measurement configuration used for that type of signal.
5.7

External Units Power Supply

The PRODIG-3 can supply the voltage needed to power the external units
(antenna preamplifiers, in the case of terrestrial TV, LNB in the case of satellite TV, or
IF simulators).
Page 26
), next enter the frequency value in MHz using the numeric
[25] key search starts until it finds a transmission with a
[17] to switch between analogue and digital channels. Press the
USER'S MANUAL. PRODIG-3
03/2008