Dc Current; Ac Current - koban KM 8212 Manual De Instrucciones

Warning
Risk of electric shock. Be sure
all power to circuit is off and
capacitors have fully discharged
before measuring continuity.

DC current

Warning
Risk of electric shock. Never
measure current where open
circuit voltages exceed 250V to
prevent damage to the meter or
personal injury.
1. Use the probe cover if making
measurements on category III or
above installations.
2. Insert the black test lead into the
COM jack.
3. Turn the rotary switch to the

AC current

Warning
Risk of electric shock. Never
measure current where open
circuit voltages exceed 250V to
prevent damage to the meter or
personal injury.
1. Use the probe cover if making
measurements on category III or
above installations.
www.grupotemper.com
Pen type multimeter
Note:
• lf the leads are not connected or
the resistance is higher than 200Ω,
the display will show "OL".
position.
4. The default mode is DC current.
Press RAN to switch to manual
range if needed.
5. Connect the test probe and test
lead in series with the circuit under
measurement.
6. The display will show the measured
value. Observe the polarity of
the test probe for DC current
mesurements.
Note:
• "OL" indicated an over-range
situation in manual mode. A higher
range should be selected.
2. Insert the black test lead into the
COM jack.
3. Turn the rotary switch to the
position.
4. The default mode is DC current.
Press FUNC to switch to AC
current. Press RAN to switch to
manual range if needed.
5. Connect the test probe and test
lead in series with the circuit under
measurement.
6. The display will show the measured
value.
Instructions manual |
KM 8212
33