Dc Current Measurements - koban KMDS01 Instrucciones Operativas

KMDS01
AUTORANGING MULTIMETER
3. Touch the test probe tips to the circuit under test.
4. Read the voltage in the display. The display will indicate the
proper decimal point, value and symbol (AC, V, etc.).

DC CURRENT MEASUREMENTS

1. For current measurements up to 2000 A DC, set the function
switch to the
plug into the ( A) jack.
2. For current measurements up to 200mA DC, set the function
switch to the mA range and insert the red test lead banana plug
into the (mA) jack.
3. Press the MODE button until "DC" appears in the display.
4. Remove power from the circuit under test, then open up the
circuit at the point where you wish to measure current.
5. Touch the black test probe tip to the negative side of the circuit.
Touch the red test probe tip to the positive side of the circuit.
6. Apply power to the circuit.
7. Read the current in the display. The display will indicate the
proper decimal point, value and symbol.
12
A position and insert the red test lead banana



www.grupotemper.com