General Specifications; Operation; Ac/Dc Current Measurements; Ac Voltage Measurement - koban KPAW-01A Manual Del Usuario

KPAW-01A

4. General Specifications

Clamp jaw opening 1.9"(48mm)approx.
φ140*180mm
Flexible coil
Display 3-6/7 digits(6000 counts)backlit LCD
Continuity check Threshold 50Ω; Test current <0.5mA
Test current of 1.5mA typical;

Diode test

Open circuit voltage <3VDC typical
Low Battery indication ' ' is displayed
[]
Over-range indication 'OL' display
Measurement rate 3 readings per second, nominal
PEAK Captures peaks >1ms
INRUSH 100MS
Temperature sensor Type K thermocouple
Input Impedance 10MΩ(VDC and VAC)
AC response True RMS(AAC and VAC)
Operating Temperature 5˚C to 40˚C(41˚F to 104˚F)
Storage Temperature -20˚C to 60˚C(-4˚F to 140˚F)
Max 80% up to 31˚C(87˚F) decreasing
Operating Humidity
linearly to 50% at 40˚C(104˚F)
Storage Humidity <80%
Operating Altitude
2000meters (7000ft.)maximum.
Battery
One(1) 9V Battery
Auto Power OFF
After approx. 15 minutes
For indoor use and in accordance with the
requirements for double insulation to
Safety IEC1010-1(2001): EN61010-1(2001)
Overvoltage Category III 1000V and
Category IV 600V, Pollution Degree 2.
8
EN EN

5. Operation

NOTES: Read and understand all Warning and Caution statements in this operation
manual prior to using this meter. Set the function select switch to the OFF position
when the meter is not in use.

5-1. AC/DC Current Measurements

WARNING: Ensure that the test leads are disconnected from the meter before making
current clamp measurements.
• Set the Function switch to the 1000A, 600A or 60A range. If the approx. Range
of the measurement is not known, select the highest range then move to the
lower ranges if necessary.
• In DC current mode Press the
• Use the MODE button to select AC or DC Current.
• Press the trigger to open jaw. Fully enclose only one conductor. For optimum
results, center the conductor in the jaw.
• The clamp meter LCD will display the reading.

5-2. AC Voltage Measurement

• Insert the black test lead into the negative COM terminal and the red test lead into the
positive V CAP TEMP Hz Ω terminal.
• Set the function switch to the V~ position.
• Connect the test leads in parallel to the circuit under test.
• Read the voltage measurement on the LCD display

5-3. DC Voltage Measurement

• Insert the black test lead into the negative COM terminal and the red test lead into the
positive V CAP TEMP Hz Ω terminal.
• Set the function switch to the V- position.
• Connect the test leads in parallel to the circuit under test.
• Read the voltage measurement on the LCD display.

5-4. Resistance

• Insert the black test lead into the negative COM terminal and the red test lead into the
V CAP TEMP Hz Ω positive terminal.
• Set the function switch to the Ω
• Touch the test probe tips across the circuit or component under test.
• Read the resistance on the LCD display.
KPAW-01A
FLASH/ZERO button to zero the meter display.
CAP position.
9