Unpacking Your Microwave Built-in
Drawer
z
z
Remove all packing materials from inside the Micro-
wave Built-in Drawer. DO NOT REMOVE THE WAVE-
GUIDE COVER. The Waveguide Cover is attached to
the ceiling of the Microwave Built-in Drawer. The mica
cover is dark grey and cardboard-like, and measures
approximately 9" x 10". The Waveguide Cover must
remain in place at all times. Never allow children to
play with packaging material.
z
z
Check the drawer for any damage, such as a
misaligned or bent drawer, damaged drawer seals or
sealing surfaces, broken or loose drawer guides or
dents inside the cavity or on the front of the drawer.
If there is any damage, do not operate the Microwave
Built-in Drawer. Contact your dealer or Gaggenau
Customer Support.
Sealing
Surface
Waveguide
Cover
Figure 1
4
Sealing
Surface
Oven Cavity
Important Notes to the Installer
z
z
Unit is heavy and requires at least two people or
proper equipment to move.
z
z
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
z
z
Read and understand the contents of this Installation
Manual before installing the Microwave Built-in
Drawer.
z
z
Remove all packing material before connecting the
electrical supply.
z
z
It is the responsibility of the owner and the installer
to assure compliance with all applicable safety codes
and standards. See UL 923, The Microwave Cooking
Appliances.
z
z
The unit may be installed using a standard or flush
(inset) installation per the following instructions.
Important Notes to the Consumer
Keep this manual with your Use and Care Guide for future
reference.
z
z
As when using any microwave oven generating heat,
there are certain safety precautions you should follow.
These are listed in the Use and Care Guide. Read all
and follow carefully.
z
z
Be sure your Microwave Built-in Drawer is installed
and grounded properly by a qualified installer or
service technician.
WARNING
The appliance should only be installed by a
licensed electrician or a qualified technician.