Part Names and Functions
Front Panel (SDX-D500C/D400C)
8
Part 1. Introduction
BUSY
3
1
AIT Data Cartridge Receptacle
See page 14 for information on inserting and removing a AIT data
cartridge.
2
POWER Indicator
Lights while the drive is on.
3
BUSY Indicator
Lights when data is being transferred through the SCSI interface. This
indicator also lights under the following conditions:
Drive is reading or writing normally: repeated blinking (same on-off
4
TAPE Indicator
When a AIT cartridge is installed, this indicator lights. This also lights
under the following conditions:
Inserting and removing a cartridge: repeated blinking (same on-off
Cartridge deteriorated:
5
STATUS Indicator
Lights when an inserted cartridge is write-protected. This indicator also
lights under the following conditions:
Drive needs cleaning:
End of Tape during cleaning:
Drive Malfunctioning:
1
TAPE
STATUS
4
5
6
Figure 1-2. Front panel
interval).
interval).
alternating long-short blinking.
repeating long-on, short-off
blinking.
repeating blinking (same on-off
interval).
repeating short-on (once or twice),
long-off blinking.
2
POWER
7