Programming Instructions - Gemini CD-12 Manual De Funcionamiento

To fine tune a cue point, pause play at the memorized cue point, then
use the SCAN BUTTONS (13) to scan frame by frame (1/75th of a
second) to where you want play to begin. Press the PLAY/PAUSE
BUTTON (10) to save the new cue point.
Note: During fine tuning there will be a stutter effect (to help you
find the beat). The stuttering effect will end when you press the
PLAY/PAUSE BUTTON (10) to save the cue point. Also, during
fine tuning if you hold down the SCAN BUTTONS (13), the unit
will scan quickly after 10 frames.

PROGRAMMING INSTRUCTIONS

1. To program the unit to play songs in the order you select using the
TRACK NUMBERS (15) on the remote control, follow these instruc-
tions:
In stop mode, press the PROGRAM BUTTON (6) and then choose
the tracks you wish to play by pressing the TRACK NUMBERS (15)
on the remote control. Press the PLAY/PAUSE BUTTON (10) to play
your programmed selections.
2. To program the unit to play songs in the order you select using the
SCAN BUTTONS (13), follow these instructions:
In stop mode, press the PROGRAM BUTTON (6) and then choose
the track you wish to play using the TRACK SKIP BUTTONS (12).
Press the PROGRAM BUTTON (6) to save the track. Repeat the
process until you are ready to start playing your selections. Press the
PLAY/PAUSE BUTTON (10) to play your programmed selections.
3. To clear items from your program, press the STOP/CLEAR BUTTON
(11).
TROUBLE SHOOTING
• If the disk will not play, check to see if the disc was loaded correctly
(label side up). Also check the disc for excessive dirt, scratches, etc.
• If the disc turns but there is no sound, check the cable connections. If
they are okay, check your amplifier or receiver.
• If the CD skips, check the CD for dirt or scratches. Do not assume
that the CD player is defective. Many CDs are recorded out of spec
and will skip on most or all CD players. Before sending the unit in for
repair, try playing a CD that you are sure plays properly.
SPECIFICATIONS
GENERAL:
Type....................Compact
Disc Type............................... Standard Compact discs (12 cm & 8 cm)
Time Display.....................Track Elapsed, Track Remain, or Total remain
Variable Pitch...........................+/- 8% Slider with Resume Switch
Start....................................................Within
Track Selection....................................................1 to 99 Tracks
Installation...............................................19" Rack Mountable
AUDIO SECTION:
Quantization......................................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..................................................................8 Times
Sampling Frequency......................................................44.1 kHz
Frequency Response....................................20 Hz to 20 kHz
Total Harmonic Distortion......................................Less Than 0.05%
Signal to Noise Ratio...................................................>96 dB
Dynamic Range.................................................................>94 dB
Output Level (nominal).............................................1.9 Volts R.M.S.
Power Supply......................................AC 120/230V, 60/50 Hz
Dimensions...............................16.5" x 10.6" x 3.5" (420 x 270 x 90 mm)
Weight...........................................................7.75 lbs. (3.5 kg)
* Specifications and design are subject to change without notice for
purpose of improvement.
Page 4
Disc Player w/wireless
0.03 seconds
remote