To Replace A Broken Or Worn Starter Rope - Husqvarna 585, 592 XP, 592 XPG Manuel Del Usuario

To adjust the low speed needle (L)
• Turn the low speed needle clockwise until stop.
Note:
If the product has a bad acceleration
capacity or if the idle speed is not correct, turn the
low speed needle counterclockwise. Turn the low
speed needle until the acceleration capacity and idle
speed is correct.
To adjust the idle speed screw (T)
1. Start the product.
2. Turn the idle speed screw clockwise until the saw
chain starts to rotate.
3. Turn the idle speed screw counterclockwise until the
saw chain stops.
Note:
The idle speed is correctly adjusted when the
engine runs correctly in all positions. The idle speed
must also be safely below the speed at which the saw
chain starts to rotate.
WARNING:
stop when you turn the idle speed screw,
speak to your servicing dealer. Do not use
the product until it is correctly adjusted.
To adjust the high speed needle (H)
The engine is adjusted at the factory to operate at sea
level. At higher altitudes, in different weather or different
temperatures it can be necessary to adjust the high
speed needle.
• Turn the high speed needle to make adjustments.
CAUTION:
speed needle screw across the
adjustment limitation stop. This can
cause damage to the piston and the
cylinder.
To examine if the carburetor is correctly
adjusted
• Make sure that the product has the correct
acceleration capacity.
• Make sure that the product 4-cycles a little at full
throttle.
• Make sure that the saw chain does not rotate at idle
speed.
• If the product is not easy to start or has less
acceleration capacity, adjust the low and high speed
needles.
CAUTION:
can cause damage to the engine.
1471 - 001 - 18.02.2021
If the saw chain does not
Do not turn the high
Incorrect adjustments
To replace a broken or worn starter
rope
1. Loosen the screws to the starter housing.
2. Remove the starter housing.
3. Pull out the starter rope approximately 30 cm/12 in.
and put it in the notch on the pulley.
4. Let the pulley rotate slowly rearward to release the
recoil spring.
5. Remove the center screw and remove the pulley.
WARNING:
when you replace the return spring or
the starter rope. The recoil spring is in
tension when it is wound up in the starter
housing. If you are not careful, it can
eject and cause injuries. Use protective
glasses and protective gloves.
6. Remove the used starter rope from the handle and
the pulley.
7. Attach a new starter rope to the pulley. Wind the
starter rope approximately 3 turns around the pulley.
8. Pull the starter rope through the hole in the starter
housing and the starter rope handle.
You must be careful
27