Tabla de contenido
Idiomas disponibles
Idiomas disponibles
en-us
3.
Switching the appliance ON
To guarantee the accuracy of the following working
steps and thus the appearance of the overall kitchen
front later on, the appliance should now be operated.
1.
Open the appliance door.
2.
Press the POWER button.
3.
Press the POWER button again to shut off.
Only for appliances with a water connection:
In order to avoid the risk of damage caused by leaking
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.
4.
Preparing the door panels
Important note:
When performing any work on the door panels, always
observe the following:
Always screw into the best load-bearing material
■
of the door panel.
Never screw into fillers, decorative strips or
■
similar.
Select a screw length which is always shorter than
■
the thickness of the door panel.
To prevent damage, protect surfaces of the door
■
panels during installation.
The total weight of the door panel must not exceed the
following values:
18" Appliance
44 Ibs/20 kg
30" Appliance
64 Ibs/29 kg
5.
Loading the appliance door
When attaching the door panels, it is recommended to
load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
18" Appliance
22 Ibs/10 kg
30" Appliance
44 Ibs/20 kg
18
6.
Removing the installation support
part
Unscrew the positioning aid from the appliance door.
Note:
Store the positioning aids, there will be used in an
installation step later.
7.
Attaching the adjusting rail to the
door panel
1.
Measure the distance A between the adjusting rail
and the overhead cabinet/fixtures.
2.
Loosen the 2 nuts (a) and remove the adjusting
rail (b).
3.
Mark this amount A on the rear of the door panel.
4.
Determine and mark the centerline of the door
panel.
5.
Put on the adjusting rail and align along the
marks. Mark the drill holes.
6.
Drill the holes.
Capítulos
Tabla de contenido
