Programming Coffee Doses; Programming Hot Water - Nuova Simonelli APPIA II V 2GR Manual Del Usuario

7.
PROGRAMMING APPIA V
7.1
PROGRAMMING DOSES
To access the programming units, proceed as
follows:
NOTE: the procedure can be carried out with
the machine on.
group, it is necessary to hold down the con-
tinued delivery key
first group also enables the setting mode for
the machine's operating parameters.
7.2
PROGRAMMING
COFFEE DOSES
To programme the amount of water for each of
the delivery keys, proceed as follows:
coffee (the double or single filter holder can
be used, according to the key to be pro-
grammed).
once the required quantity has been deliv-
ered, press the continued key
38
key will switch off (the other keys will con-
tinue to flash).
the programming function or to continue
programming other dose keys
NOTE: This procedure can be used for all
groups on the machine, although it
must be performed on one group at a
time; the other groups will continue to
operate as normal.
for 5 seconds.
7.3
PROGRAMMING HOT
WATER
programming function.
and then press the
programming function or to continue pro-
gramming other selection keys.
7.4
PROGRAMMING THE
CUP WARMER (optional)
group following the usual procedure.
.
group will respectively show the automatic
switch on and off times, while the continuous
keys
will flash.
to exit
As shown in the table, each of the delivery
keys has an associated value; the switch on
time for the cup warmer is given by sum-
ming the values for the lit keys of the first
group. The same calculation method is used
for the switch off time of the cup warmer,
using the keys of the second group.
Key
(on time)
.
key again
to exit the
for the first and second group
Group 1 Group 2
(off time)
2 min. 5 min.
10 min.
4 min.
8 min. 20 min.
40 min.
16 min.