Attaching Bowl To Mixer - Waring Commercial WSM10L Manual De Instrucciones

ABOUT THE REMOVABLE BOWL GUARD
(Models WSM10L and WSM20L)
The interlocking bowl guard is easy to remove and reattach for easy
cleaning in a sink or dishwasher.
NOTE: When bowl guard is open or not properly installed, mixer will
not operate.
NOTE: Rotate bowl guard clockwise (open) and counterclockwise
(closed) to attach agitators to mixer.
Opening/Rotating Bowl Guard:
Rotating bowl guard clockwise (open) and counterclockwise (closed),
allows the operator to easily add ingredients to, and to properly
remove the agitator and bowl from mixer.
Removing and Attaching the Bowl Guard:
NOTE: Before removing or attaching the bowl
guard, make sure the bowl is in the down/
lowered position and the agitator tool is off
the shaft.

ATTACHING BOWL TO MIXER

1. Lower cradle by pulling lift lever forward
and down to its resting position.
2. Lift bowl by bowl handles and:
a) Slowly position locking pin (located
on the rear of bowl) into the hole in
middle rear of cradle (Fig. 1).
b) Lower bowl onto pins located on
either side of bowl cradle.
3. Once bowl is positioned on cradle,
secure bowl by pulling each bowl
clamp forward until bowl is locked
tight (Fig. 2).
9
FIG. 1
FIG. 2