Tabla de contenido
ADC-RES Controller configuration mode:
Press and hold the selection button:
Now release the selection button.
Press:
or
or
or
Press:
OR
The words "Yes" or "no" flash on screen when the up or down arrow is pressed and
then the controller exits configuration mode. The screen then displays the hours of
operation* once more.
The main switch should now be set to "OFF/RESET".
* On the display for hours of operation, X denotes any figure between 0 and 9.
Figure 2.39: Configuration mode (nominal voltage/frequency settings, configuration of the engine type),
RES 18 EC / RES 12 TEC / RES 16 TEC
Move the main switch on the generating set to "RUN". (The
generating set engine does not start.)
Wait approximately 5 seconds; the screen displays the
program version number. (this number may be different from
the number indicated here).
Press on the down arrow, then the up arrow and repeat this
twice to switch to configuration mode. (This key combination
serves as a "password" for the controller.)
The voltage/frequency torque is adjusted.
To move to the next setting, engine type ("Ec" code).
To select the engine type, as required.
To move to the next setting, communication setting ("Cn" code).
To change the communication setting if necessary. See
figure 2.35
To enter setting and move to SAVE mode.
To save the changes.
To cancel the changes, without saving.
RES 12 TEC
RES 18 EC
RES 16 TEC
40/73
Display:
.
0
v
1
1
3
U
u
0
1
U
u
0
x
E
c
0
0
E
c
1
2
C
n
0
x
S
A
V
E
Y
E
S
n
o
X
X
X
X
Capítulos
Tabla de contenido
