WEG IOA-01 Guía De Instalación, Configuración Y Operación página 6

To correctly install modules IOA-01 and IOB-01, follow the steps below:
Step 1: While the drive is powered off, remove the front cover of the CFW11 (figure 2);
Step 2: Carefully connect the module into slot 1 (figure 3(a));
Step 3: Place and tighten the grounding screw of the module (figure 3(b));
Step 4: Set the module switches as shown in table 1;
Step 5: Connect the signal cables to the XC2 (IOA-01) or XC3 (IOB-01) connector.
a
c
b
Figure 2: Removal of front cover
a
b
Figure 3: Installation of optional module into slot
2