Print Head & Rollers - Brother P-touch 2400 Manual Del Usuario

Occasionally, specks of dust or dirt become attached to the machine's print head and rollers.
This is particularly likely when you are using the unit outdoors or in a very dusty environment.
If a section of the print head is covered with dust, a blank horizontal streak may appear
through the label text. Therefore, as with a tape recorder, the machine's head may need to be
cleaned from time to time.
To clean the print head and rollers:
1 Turn off the machine.
2 Open the tape compartment cover, then remove the tape cassette if one is installed. The
print head and rollers are located in the tape compartment.
3 Print head: Use a dry cotton swab to gently wipe the print head with an up-and-down
motion.
Rollers: Use a dry cotton swab to wipe each roller with an up-and-down motion while
rotating them with your finger.
4 Install a tape cassette, close the tape compartment cover, and then try printing again.
5 If dust still remains, repeat steps 3 and 4 using a cotton swab dipped in isopropyl (rub-
bing) alcohol.
If none of the above works, contact your service representative.
PRINT HEAD & ROLLERS
Print head
Print head
Rollers
Cotton swab
25