Removing From Carton; Assembly; Fuel Recommendations; Adding Fuel - Craftsman 247.88704 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

NOTE: References to right or left side of the snow thrower are
determined from behind the unit in the operating position (standing
directly behind the snow thrower, facing the handle panel).

remoVing from Carton

1.
Cut the corners of the carton and lay the sides flat on the ground.
Remove and discard all packing inserts.
2.
Move the snow thrower out of the carton.
3.
Make certain the carton has been completely emptied before
discarding it.

assembLy

Positioning the Upper Handle
1.
Pivot the upper handle into the operating position making sure not to
pinch the cable in the process, as illustrated in Figure 1, until it
clicks into place.
Figure 1
ASSEMBLY
2.
Tighten the wing knobs to secure the handle in place.
See Figure 2.
set-UP

fuel recommendations

Use automotive gasoline (unleaded or low leaded to minimize combus-
tion chamber deposits) with a minimum of 87 octane. Gasoline with
up to 10% ethanol or 15% MTBE (Methyl Tertiary Butyl Ether) can be
used. Never use an oil/gasoline mixture or dirty gasoline. Avoid getting
dirt, dust, or water in the fuel tank. DO NOT use E85 gasoline.
Refuel in a well-ventilated area with the engine stopped. Do not
smoke or allow flames or sparks in the area where the engine is
refueled or where gasoline is stored.
Do not overfill the fuel tank. After refueling, make sure the tank
cap is closed properly and securely.
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor
may ignite. If any fuel is spilled, make sure the area is dry before
starting the engine.
Avoid repeated or prolonged contact with skin or breathing of
vapor.

adding fuel

Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running. Extinguish cigarettes,
cigars, pipes and other sources of ignition.
Always keep hands and feet clear of equipment moving parts. Do not
use a pressurized starting fluid. Vapors are flammable.
1.
Remove the gas cap, check the fuel level and add fuel if necessary.
7
Figure 2
Warning
Warning
Tabla de contenido

Solución de problemas

loading

Tabla de contenido