Zipper Maschinen ZI-HS5TN Instrucciones De Servicio página 35

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HS5TN; ZI-HS7TU
ASSEMBLY ZI-HS5TN & ZI-HS7TU
C. Log tray right: Align the two mounting
holes of log tray right with the holes on
the rear of the splitter. Insert one socket
head cap screw M6×12 and a spring
washer 6 into the mounting hole on the
left side, another socket head cap screw
M6×12 and lock nut M6 on the right side
and tighten both screws firmly (1).
Then loosen the cup head bolt and nut on
the left side of the front leg, insert the
open end of support strut 1 onto the bolt
and tighten the nut.
Connect the upper end of support strut 1
by means of a cross recessed pan head
screw M6×12 and lock nut M6 with log
tray 1 and tighten the screw (2).
D. Log tray left: Align the two mounting
holes of log tray left with the holes on the
front of the splitter. Insert a socket head
cap screw M6×12 and a spring washer 6
into the mounting hole on the right side,
another socket head cap screw M6×12
and lock nut M6 on the left side and
tighten both screws firmly.
Then loosen the cup head bolt and nut on
the right side of the front leg, insert the
open end of support strut 1 onto the bolt
and tighten the nut.
Connect the upper end of the support
strut 1 with the cross recessed pan head
screw M6×12 and the counter nut M6 with
log tray 2 and tighten the screw.
35