Before You Start Playing; Connecting The Pedal Cable; Connecting The Speaker Cable; Connect The Power Cord - Roland HP-107e Manual Del Usuario

Before You Start Playing

Connecting the Pedal Cable

Insert the pedal cable into the Pedal connector on
the rear panel of the HP107e.
Connecting the Speaker
Cable
As shown in the diagram, connect the speaker
cable leading from the speaker box of the stand to
the speaker connector located on the rear bottom
of the HP107e.
Push the speaker cable in until it clicks into position.
Clip portion
Do not put anything that contains water (e.g., flower
NOTE
vases) on this unit. Also, avoid the use of insecticides,
perfumes, alcohol, nail polish, spray cans, etc., near the
unit.
The speakers of this piano are mounted beneath the upper
surface, and face upwards. Malfunctions or accidents
may occur if liquids contact any part of the speakers.
Speakers
Speaker connector
Speaker cable

Connect the Power Cord

1. Insert the included power cord into the AC inlet
on the bottom panel of the HP107e.
2. Plug the power cord into a power outlet.
Use only the attached power-supply cord.
NOTE

Setting Up the Music Rest

1. Grasping the music rest with both hands, lift it
toward you until its in the upright position.
2. Use the support on the back of the music rest to
keep the stand in place.
The angle of the music rest can be set to any of three posi-
tions.
2
I Folding down the music rest
Raise the support located on the back of the music
rest, then gently fold down the music rest.
I Using the music holders
You can use the holders to hold pages in place. When not
using the holders, leave them folded down.
Before You Start Playing
1
9