Adjusting The Kick Panel - Thermador PROFESSIONAL PRO HARMONY PRD304GHC Manual De Instalación

Griddle Tilt Adjustment
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Figure 30: Griddle Leveling Screws
WARNING:
To avoid risk of injury, never operate the griddle without
the griddle plate installed. Never use griddle in a manner
that is not prescribed by the Use and Care Guide.
The griddle plate must always be in place when the
griddle is turned on.
English 26
(not all models)
Move griddle
plate to the
side and turn
leveling screws

Adjusting the Kick Panel

To adjust the kick panel do the following:
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Slightly push panel up then out to clear base
protrusions.
3. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall Torx screw.
4. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½" (12.7 mm) clearance above the floor.
Figure 31: Kick Panel Adjustment