Mount Handgrip; Assemble/Set Protective Hood; Installing/Changing Disc - Parkside PWS 125 D3 Traducción Del Manual De Instrucciones Original

GB IE

Mount handgrip

The device must only be
operated with the handgrip
mounted.
Depending on the method of working, tigh-
ten the handgrip (
thread on the left (
tion ) or top (
Assemble/set protective
hood
Adjust the protective hood such that any
sparks or detached parts cannot hit either
the user or any bystanders.
The protective hood must also be positi-
oned such that the sparks cannot ignite
combustible parts, including those in the
surroundings.
1. Press the spindle stop button (
2. Turn the mounting spindle (
the spindle lock fixed the mounting
spindle. Keep and continue to hold
down the spindle lock button (
3. Release the clamping nut (
the chuck key (
the spindle lock button (
4. Take off the locknut (
adapter flange (
le flange ( 17).
5. Open the tightening lever (
6. Place the protective hood
( 14) on the positioning holes.
7. Turn the protective hood (
the working position. The closed side
of the protective hood must always
face the operator.
8. Close the tightening lever (
again. The protective hood should not
be able to be turned any more.
3 6
1) on to the handgrip
8), right (see illustra-
2) of the device.
9).
17) until
9)
16) with
13). You can release
9).
16) and the
15) from the spind-
19).
14) into
19)
9. Install the locknut (
flange ( 15) in reverse order.
10. Readjust the position of the protective
hood if you find during use that it does
not provide optimum protection.
If needed, the tension on the adjustment
nut ( 18) can be set. Use the chuck key
( 13) for this.

Installing/changing disc

1. Press the spindle stop button (9).
2. Turn the mounting spindle (17) until the
spindle lock fixed the mounting spind-
le. Keep and continue to hold down
the spindle lock button (9)
3. Release the clamping nut (16) with the
chuck key (13). You can release the
spindle lock button (9).
4. Set the desired disc onto the moun-
ting flange (
should always face the device.
If the rotary direction is in-
dicated on your disc, ensure
that it corresponds to the
rotary direction of the angle
grinder when mounting. This
is indicated on the device
next to the spindle stop but-
ton (9) (
Ensure that the flange (
placed on the device in such a way
that the recesses in the flange grip
into the edge of the device. The
mounting spindle (
simultaneously when you turn the
flange.
5. Set the clamping nut (16) on the moun-
ting spindel (17) again. The flat side of
the clamping nut must face the attach-
16) and adapter
15). label on the disc
).
15) is
17) must turn