Filling The Water Tray; Safety Recommendations - Sima MAGNUM 700 Manual De Instrucciones

3.3 FILLING THE WATER TRAY

The table saws, model MAGNUM 1000 / 900 / 700 are designed to work with diamond disks cooled by water.
Therefore, an important part of the frame is a tray intended to serve as the cooling water deposit pumped in a closed
circuit to disk.
WARNING: Before plugging the machine to the electricity to effectuate any cutting operation, the water tray
should be filled until the pump has been completely covered.
During cutting operations, a large amount of dirt is accumulated in the tray. Thus, you have to change the
water as often as necessary to ensure the smooth functioning of the pump and the perfect cooling of the disk. The tray
has a stopper to remove once you want to change the water.
To protect the water pump from dirt and avoid that the mud would block it, you need to insert it into the
circular separator to found in the bottom of the water tray.
The water tray has a stopper D Fig. 1 used to easily empty the tray after each work.
WARNING: The water pump needs to be totally covered by water. Water is crucial for the cooling of the
blade.

4. SAFETY RECOMMENDATIONS

Table saws, model MAGNUM 700, 900 and 1000 are only to be used by familiarised people with its
functioning.
• Before starting up the machine please read the instructions and make sure safety norms are respected.
Learn how to stop the machine in a fast and safe way.
• Place the machine on a plane surface. Connect the machine to the electricity only when you are sure of its
stability.
• Make sure the machine you are going to use is a perfect technical state and totally operational.
• Do not start the machine if you have assembled all the safeguards that come with the machine.
• It is recommended to use safety goggles, safety boots, gloves etc. Always use approved materials.
• Always use Individual Protection Equipment (IPE) in accordance with the type of work you are effectuating
• Prohibit strangers to access the place of work of the machine.
• Work clothes are not supposed to have loose articles that can cling into movable parts of the machine.
• When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
• Use the blades indicated in this manual.
• Never use the machine for purposes other than those it has been designed for.
VERY IMPORTANT: Always use earth plug before starting-up the machine.
• Use normalised extension cables
• Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the machine.
• Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp edges.
Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the machine.
• Do not use high pressure water to clean circuits or electrical elements.
• The electrical cables that cause any cut or other problems need to be changes the soonest possible.
• Keep the elements of protection and safety close to you.
• Unplug the machine and do not handle the machine nor operate on its mechanical or electrical elements
the motor is on.
WARNING: Read carefully the instructions mentioned in the present manual and make sure all safety and
prevention norms of the place of work are respected.
-8-
ENGLISH
while