Mounting And Dismounting The Blade; Starting And Using Instructions; Position Of The Machineand The Operator. Plugging And Unplugging; Adjusting The Height - Sima MAGNUM 700 Manual De Instrucciones

7. MOUNTING AND DISMOUNTING THE BLADE

The table saws MAGNUM 1000 / 900 / 700 have been designed to use diamond segmented blades or blades with
continuous rim with 700 / 900 / 1000mm diameters.
7.1 MOUNTING OR REPLACING A CUTTING BLADE
To mount or replace a cutting blade, proceed as follows:
• Make sure the power supply cable of the machine is disconnected.
• Remove the blade safeguard (P, Fig.3) loosening the screws that fix it (A, Fig.3).
• Block the rotation of the axis inserting a key (C, Fig.3) in the slots of the shaft.
• Loosen the nut (D, Fig.3) with spanner (E, Fig.3). Remove the exterior flange (F, Fig.3).
• Place the blade on its axis ensuring it is well centred and perfectly located.
• Place the exterior flange back and tighten the axis nut using the set of spanners used before.
• Check the coupling between the blade and the flanges before tightening the nut.
Make sure the rotation sense of the blade is correct, it shout match with the arrow marked on the blade and that
marked on the safeguard.
Place the lateral part of the safeguard in its position and tighten it.
WARNING: Remove the tools used and make sure that all the elements of the machine have been placed in
their correct position. Never use the machine without the blade safeguard place in its position.
• Now, you can plug the machine.
• To dismount the blade, proceed to the reverse.

8. STARTING AND USING INSTRUCTIONS

8.1 POSITION OF THE MACHINEAND THE OPERATOR. PLUGGING AND UNPLUGGING

The machine needs to be installed in well illuminated, stable and plane surface, free from any obstacles.
Before starting-up the machine, we should have made all necessary safety measures (electrical connection,
stability, protections, etc....) as mentioned in the previous chapters.
When installing the machine, make sure the table on which it will be placed should be a horizontal, non bland
surface.
This machine DOES NOT HAVE TO BE USED UNDER THE RAIN. ALWAYS WORK IN WELL
ILLUMIINATED AREAS.
To start cutting, the operator should stand in from of the machine. In this position, the operator can easily
manage the cutting head and the piece to be cut. He/she will also have easy access to the electrical plug. Fig 4
Once the power supply cable is connected, we proceed with starting the motor as per the following steps:
1º Open the starter security door B Fig.4 and press the black START button (leave the security door open
while using the machine).
2º press the start button "I" (white) (D, Fig.4).
To stop the machine, press the button "0" (black) (C, Fig.4). When you press the emergency stop (E,
Fig.4) the machine will right away stop. To restart the machine, turn the emergency stop quart away and press the
START button "I".

8.2 ADJUSTING THE HEIGHT

The cutting head of the machine has been designed in a way to raise it or lower it by loosening the lever
(D Fig.5)
-10-
ENGLISH