G-U BKS B-1893 Serie Manual De Instalación página 57

Blink code Problem
Sensor "Unlocked" po-
sition of active leaf not
reached
Sensor "Unlocked" posi-
tion not fully reached
Critical error
Motor error
Programming mode
active
Once the error has been eliminated, the blink codes in the controller must be acknowledged
(see point 6.3).
Cause
y y Load on active leaf too y y
high
y y
y y Foreign object in the y y
lock
y y Sensor connected y y
incorrectly
y y
Connection cable
defective
y y Load on passive leaf y y
too high
y y
y y Foreign object in the y y
lock
y y Test run not carried y y
out
y y Test run not y y
completed
successfully y y
Then repeat test run in
each case (see point 6)
y y "Locked" position y y
not reached
2x consecutively y y
y y Lock blocked y y
y y Service plug not y y
removed
Help
Check whether the
door leaf or door
frame is twisted or
warped
Insufficient power in
power supply unit
(see point 2.2)
Check the lock for
foreign objects
Check wiring
(BK, GY, WHGN)
Check whether the
door leaf or door
frame is twisted or
warped
Insufficient power in
power supply unit
(see point 2.2)
Check the lock for
foreign objects
Perform test run
(see point 3.2 or 6)
Open door leaf for
test run and hold open
Eliminate error as indi-
cated by blink code
Check the lock for
foreign objects
Load on door system
too great
Replace lock
Exit programming
mode (see point 6.2)
57