Replacing The Stylus - 1byone 471NA-0006 Manual De Instrucciones

Note:
EN
When playing records, sound output of the built-in amplifier is limited to
avoid feedback and rumble. This is normal. Keep the volume as low as possi-
DE
ble on the turntable and instead increase volume on the external amplifier.
FR
Adaptor for 45 RPM (Accessory)
ES
This adaptor allows you to play 45 RPM records.
1. Gently place your 45 RPM record onto the turntable.
IT
2. Place the 45 RPM adaptor over the spindle.
3. Follow normal turntable operation steps to play your record.
Listening to a USB Device
USB Device Playback (Support MP3 Files)
1. Toggle the Function selector to USB position.
2. Insert a USB device into the USB port and it will start playing.
3. Turn the Volume control dial to the desired level.
4. When removing the USB device, first press the USB Play/Pause
stop playing.
Play/Pause Control
Press the USB Play/Pause button to pause or resume playback.
Skip Track
During playback, press the USB Skip/Search
previous or next track.
High-Speed Music Search
1. During playback, press and hold the USB Skip/Search
skip/search through the current track at high speed in forward or backward
directions.
2. When the USB Skip/Search
speed will be resumed immediately.
button to
/
buttons to skip to the
/
buttons to
/
buttons are released, normal playback
07
USB Recording from Turntable
1. Insert the USB device into the USB port.
2. Toggle the Function selector to PHONO position.
3. Place the record on the turntable and move the Tone Arm to your desired
song to start playing.
4. Press the REC button to start recording. The Standby indicator will keep
flashing during recording.
5. To stop recording, press the REC button again.
6. After recording, you must return the Tone Arm to the Tone Arm Rest
manually.
7. Toggle the Function selector to USB mode for play the recorded file.
Using Aux Out ( Aux Out/Line Out )
1. You can run the audio from the turntable into your home stereo, television
or other stereo source by using the Aux Out RCA Jack.
2. To make this connection, you need a standard RCA cable. Plug the connec-
tors on one end of the cable into the AUX OUT Jack on the rear of the
turntable. The other end of the cable will plug into the Aux Input Jacks LINE
INPUT/AUDIO INPUT of your selected device.
3. Operate the turntable as usual.
NOTE: You can still listen to your turntable when using the Audio Output
feature. If you don't want sound from the turntable, turntable, you can
adjust the volume to a minimum.

Replacing the Stylus

It is suggested to replace the stylus after 400 hours of use.
Please follow the steps below (and graphic on next page) to change the
stylus:
1. Lift the Tone Arm off the Tone Arm Lock.
2. At the front end of the tone arm, place the tip of your fingernail between
the red stylus holder and the black cartridge housing as shown. Press down
on the red stylus holder until it separates from the cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard it.
4. Place the new red stylus holder with stylus under the cartridge housing.
First, press upward on the back side of the stylus holder, and then press up
on the front edge of the stylus holder until it snaps into place on the
cartridge housing.
08
EN
DE
FR
ES
IT