Replacing The Stylus; Safety Instructions - 1byone 471NA-0003 Manual De Instrucciones

EN
Play / Pause control
Press the USB PLAY/PAUSE button to pause or resume playback.
DE
FR Skip track
During playback, press the USB SKIP/SEARCH
ES
previous or next track.
JP
High-speed music search
IT
1. During playback, press and hold the USB SKIP/SEARCH
through the current track at high speed.
2. When the USB SKIP/SEARCH
will be resumed immediately.
Note:
USB flash drives with more than 32GB memory may not be compatible.
USB RECORDING FROM THE TURNTABLE
1. Insert the USB device into the USB port.
2. Rotate the SOURCE selector to PHONO mode.
3. Place the record on the turntable and move the TONE ARM to your desired song to
start playing.
4. Press the REC button to start recording. The standby LED will keep flashing during
recording.
5. To stop recording, press the REC button again.
6. After recording, you must return the TONE ARM to the TONE ARM REST manually.
7. Rotate the SOURCE selector to USB mode to play the recorded file.
USING AUDIO OUT ( Aux out/Line out )
1. You can run the audio from the turntable into your home stereo, television,or other
stereo sources by using the AUDIO OUT RCA Jacks.
/
buttons to skip to the
/
buttons to search
/
buttons are released, normal playback speed
05
2. To make this connection, you need a standard RCA cable. Plug the red and white
connectors on one end of the cable into the red and white AUDIO OUT RCA Jacks
on the rear of the turntable. The other end of the cable will plug into the AUX
INPUT Jacks ( LINE INPUT/AUDIO INPUT ) of your selected device.
3. Operate the turntable as usual.
Note:
You can still listen to your turntable when using the Audio Output feature. If you
don't want to listen from the turntable, you can adjust the volume to a minimum.

REPLACING THE STYLUS

It's suggested to replace the stylus after 400 hours of use.
Please follow the steps below to change the stylus:
1. Lift the TONE ARM off the TONE ARM LOCK.
2. At the front end of the tone arm, place the tip of your fingernail between the red
stylus holder and the black cartridge housing as shown. Press down on the red
stylus holder until it separates from the cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard it.
4. Place the new red stylus holder with stylus under the cartridge housing. First, press
upward on the back side of the stylus holder, and then press up on the front edge
of the stylus holder until it snaps into place on the cartridge housing.

SAFETY INSTRUCTIONS

1. Read these instructions and follow them.
2. Keep these instructions and heed all warnings.
3. Do not use this product near water.
4. Clean the turntable only with a dry cloth.
5. Do not block any ventilation openings.
6. Install in accordance with the manufacturer's instructions.
06
EN
DE
FR
ES
JP
IT