Controlling The Ptz Camera With An; Analog Dvr (Cvbs); Changing The Camera's Ptz Protocol Information For Analog Dvrs (Cvbs) - flir C346ZC252 Manual De Instrucciones

8 Controlling the PTZ Camera with an Analog DVR (CVBS)
8.2 Controlling the PTZ Camera with an Analog DVR (CVBS)
Once your camera is connected to an analog DVR, you must perform
initial setup to control the camera using the DVR. Once this setup is
complete, you will be able to move the camera, configure preset posi-
tions, and use other advanced controls. For a full list of supported for-
mats, see http://www.flir.com/security/MPXcomp.
The PTZ camera requires special protocol information to enable an
analog DVR to control the camera movement.
Input the following protocol information into your analog DVR's PTZ
settings menu to enable the camera's PTZ controls:
• Default Camera ID (Address): 1
• Default Baud Rate: 9600
• Default Parity: None
See your NVR's instruction manual for details.
8.3 Changing the Camera's PTZ Protocol Information for
Analog DVRs (CVBS)
Change the default protocol information on your PTZ cameras only
when using multiple PTZ cameras or if your DVR does not support the
default settings (see your DVR's instruction manual for details).
NOTE
The PTZ camera will display the configured PTZ protocol informa-
tion when it starts up. To quickly display this information, discon-
nect and reconnect the power adapter.
The PTZ protocol information on this camera is set using DIP
switches inside the camera. DIP switches represent binary values.
This means that they are either On (1) or Off (0).
#; r. 7.0/47030/47030; en-US 47