Ce Declaration Of Conformity - Telcoma Automations T21 Manual De Instrucciones

GB
IMPORTANT RECOMMENDATIONS CONCERNING INSTALLATION
Only qualified personnel having the legal requirements must install the automation according to the principles of good
workmanship and in conformity with the machinery directive 98/37/CE and standards EN12453 and EN12445.
Check that the existing structures (posts, hinges, leaves) are stable in relation to the forces developed by the motor.
Check that suitably robust limit stops have been installed for end of gate opening and closing.
Check the state of the cables that are already present in the system.
Analyse the hazards connected with the automation system and adopt the necessary safety and signalling devices
accordingly.
Install the commands (e.g. the key selector) so that the user is not placed in a hazardous area when using them.
Upon completion of the installation, test the safety, signalling and release devices of the automation system several times.
Apply the CE label or plate with information regarding the hazards and identification data on the automation.
Give the end user the instructions for use, the safety recommendations and the CE declaration of conformity.
Ensure that the user has understood the correct automatic, manual and emergency operation of the automation system.
Inform the user in writing (in the use instructions for example):
- Of possible non secluded residual risks and of foreseeable improper use.
- To disconnect the power supply when cleaning the area that is automated or when performing small maintenance
operations (e.g.: repainting).
- To frequently control that no visible damage has occurred to the automation, and to inform the installer immediately if
damage is noticed.
- Not to allow children to play in the vicinity of the automation.
Prepare a maintenance schedule for the automation installation (at least once every 6 months for the safety
devices), recording the work carried out in a special book.
DISPOSAL
This product is made up of various components that could contain pollutants. Dispose of properly!
Make enquiries concerning the recycling or disposal of the product, complying with the local laws
in force.
The undersigned Ennio Ambroso, The Legal representative of the firm:
TELCOMA S.r.l. Via Luigi Manzoni 11, 31015 Conegliano (TV) ITALY
Declares that the product:
Model: T21
Model: T31
Complies with the essential requirements of section 3 and relative provisions of the Directive 1999/5/CE, if used for
the purposes for which it has been designed.
Complies with the essential requirements of Directive 89/336 (EMC), EN61000-6-3, EN61000-6-1 and subsequent
amendments, if used for the purpose for which it has been designed.
Complies with the essential requirements of Directive 73/23 (LVD), EN60335-1 and subsequent amendments, if
used for the purpose for which it has been designed.
Place and date:
Conegliano, 01/06/2010

CE DECLARATION OF CONFORMITY

Use: Gate operator control unit
Use: Gate operator control unit
Legal Representative
Ennio Ambroso
43